20A UM001 EN P PDF

Rockwell Automation Publication 20A-TDJ-EN-P – July PowerFlex 70 Adjustable Frequency AC Drive User Manual, publication 20A-UM Publication 20A-INB-EN-P. The PowerFlex 70 drive contains protective MOVs and Common Mode. Capacitors referenced to ground (see below). To guard. posts; United States. Posted 1 Jun ยท llautomation. com/idc/groups/literature/documents/um/

Author: Fenrigis Kazijora
Country: Hungary
Language: English (Spanish)
Genre: Art
Published (Last): 7 July 2015
Pages: 492
PDF File Size: 19.42 Mb
ePub File Size: 11.3 Mb
ISBN: 794-7-42952-670-2
Downloads: 37504
Price: Free* [*Free Regsitration Required]
Uploader: Akishakar

Don’t have an account? Address the condition that caused the fault. Do not reduce wire gauge when using higher temperature wire. Enter text from picture: Posted 4 Jun If the source is an analog input, check wiring of the command.

Allen-Bradley PowerFlex 70 Installation Manual

You need to be a member in order to leave a comment. Allen-Bradley Drives Technical Support.

If the application requires the drive to be disabled without software interpretation, a hardware enable configuration can be utilized. Page of 52 Go. Go through the existing drive and make note of the value of every parameter. Press Um0001 to acknowledge the fault. Specific drive catalog numbers are listed below: Good luck and be careful. To avoid an electric shock hazard, verify that the voltage on the bus u,001 has discharged before performing any work on the drive.


The cause must be corrected before the fault can be cleared. To order paper copies of technical documentation, contact your local. Page 40 Running S. The information provided Does Not replace the User Manual and is.

The information provided Does Not replace the User Manual and is intended for qualified drive service personnel only. I suspect when you say “how to put original parameters to the new one”, you want to program a new drive with the same parameters as an existing drive.

Factory default setting is 12 volts. Then put that HMI into the new drive and Download the parameters into the new drive. Got it, continue to print. Also you should remove the HMI first before trying to remove the cover of that drive.

Sign in Already have an account? Start During a Start Up, the majority of applications require changes to only a few parameters. Share this post Link to post Share on other sites. Chapter 1 has all parameters and their parameter groups. It is very easy to do.

  LEY 11347 PDF

How to replace PowerFlex 70? – Allen Bradley –

To find your local Rockwell Automation distributor, visit. Most drives will have a jumper storage area inside the front cover. Posted 31 May If the Safe-Off board is removed from the drive, pins 3 and 4 of the Safe-Off Connector must be jumpered for the drive to run. Press the Enter key to display the Start-Up Menu. Step 1 Read the General Precautions How to replace PowerFlex 70?

Sign In Sign Up.

Author: admin